Pivot pin / needle suitable for PHF / VHB / PHM and PHBH carbs

Float pin also known as Guzzi ref. 17933167, 061527346

 This part is due back in stock soon, call 01484 841395 to reserve yours

 13933100 GU13933100 13 93 31 00
 1393 3100 1393.3100 13.93.31.00

Small stainless steel double eared hose clip for in tank fuel filter and pipe unions

This single use clip is secured by compressing the 'ear' to tighten

 This part is due back in stock soon, call 01484 841395 to reserve yours

Closing throttle cable for models affected by the 2002 factory recall, for details see CaliEVThrottleCableRecall.pdf

Affected models are: California EV: frame numbers from KD100548 to KD115984, California Special: frame numbers from KD130001 to KD131984, California Jackal: frame numbers from KD150001 to KD153177.We advise you to measure your existing cable before ordering in case you have a non standard set up.

 This part is available by special order, request a quote

 03117830 GU03117830 03 11 78 30
 0311 7830 0311.7830 03.11.78.30

Internal fuel pipe to connect fuel filter to pump in fuel tank, see FUA20004 for pipe clip

See FUA81000 for alternative part

 This part is available by special order, request a quote

GU03106170

The Mistral V-Twin boost is an effective and cost efficient way to cure the fuelling problems common to all modern fuel injected Guzzi's.
Plugging directly into the wiring harness using original connectors, with no cutting or splicing required, installation takes less than ten minutes.
The V-Twin boost features a unique technology to provide your bike with a controlled fuel enrichment.
Make your bike run as it should have done from the factory!

• Quick and easy installation
• Resistant to atmospheric agents and vibrations
• Optimized by Mistral for your bike
• Best response to the opening of the throttle
• Better torque at low-medium range
• Reduction of the on/off effect
• Correct air/fuel ratio in all conditions with real-time modification

 This part is available by special order, request a quote

Rubber used to link airbox to inlet tube FUG30560 behind throttle body

 This part is available by special order, request a quote

 30114660 GU30114660 30 11 46 60
 3011 4660 3011.4660 30.11.46.60

50cm Ariete fuel or breather pipe suitable as fuel pipe on gravity fed non injection models

Certified ethanol proof and safe for modern E10 fuel. Hose clips also available, see FUA00004

 This part is due back in stock soon, call 01484 841395 to reserve yours

A pair of K&N high performance offset air filters, fit to throttle body or inlet trumpet as part of performance tuning

Best results will be obtained when combined with a Mistral crossover and silencers

• High Air Flow with Excellent Filtration
• Designed to Increase Horsepower and Acceleration
• Washable and Reusable
• Will NOT Void Vehicle Warranty
• Lasts up to 50,000 miles before cleaning is required depending on driving conditions
• K&N Million Mile Limited Warranty
• Emissions Legal
• Economical, a K&N Air Filter Will Last the Life of Your Bike
• Works with Original Equipment Manufacturer Vehicle Electronics
• Easy High Performance Add-on
• Environmentally Friendly

 This part is due back in stock soon, call 01484 841395 to reserve yours

Genuine Weber fuel pressure regulator

 Order now and we will post your order within 7 days.

 01112800 GU01112800 01 11 28 00
 0111 2800 0111.2800 01.11.28.00

Rubber linking throttle body to airbox

Inlet tract rubber. No longer available, superceded by FUA30370

 Sorry, this part is no longer available.

 30114470 GU30114470 30 11 44 70
 3011 4470 3011.4470 30.11.44.70